Flightone Raceflight Bolt V2 4 In 1 ESC

Flightone Raceflight Bolt V2 4 In 1 ESC

The FlightOne Bolt V2 utilises the latest in ESC technology with it’s 4 in 1 design, allowing you to save valuable weight and space in your model whilst keeping the ESC board protected in the center of the frame safe from propeller strikes.

The FlightOne Bolt V2 is designed to stack with the Revolt V3 and Revolt OSD boards, again making installations tidy and precise. The Bolt V2 can be combined with a number of different flight controllers. This is made simpler with the Bolt V2 by having an ESC signal/ground wiring loom which plugs directly into the board, which cuts down on soldering and makes installations more interchangeable. A 4-6S Lipo is supported and each ESC is capable of handling up to 50 amps current draw, so you have peace of mind and flexibility when trying different Motor, Prop and ESC setups.

The Bolt V2 employs powerful FETS to supply the most power to your motors as quickly as possible. They also increase responsiveness in breaking and sharp maneuvers which ultimately increases your aircraft’s agility. The FlightOne Bolt V2 also capitalises on the Blheli_S ESC firmware for faster switching using more powerful MPU’s.

The Bolt V2 also carries a single current sensor to monitor amp draw, mAh’s consumed and battery voltages 

A 5v 3 amp BEC is still provided on the board which is capable of powering the flight controller (if using the Revolt V3) or any other 5v equipment. Use the very convenient pinout wiring diagrams to ensure you have your system wired correctly.

Specification 

• 30.5mm x 30.5mm mounting hole spacing

• Integrated FlightOne Gummies

• Upto 50 amp per channel output

• BlHeli_S

• 5V voltage regulator capable of 3A continuous output

• D-Shot ready

• 4s – 6s compatible

• Built in Current Sensor

• Special low noise connector integrated with the Revolt and Bolt pair

• Current and Voltage sent to flight controller

• Easy Install

• High-quality components

• Weight: 15.5 grams